|
| |
ARMY TM 9-4210-381-14
NAVY EE-000-CA-MMA-010/7053-AC
AIR FORCE TO 35E9-136-31
6-6 REAR EVAPORATOR PANEL
This task covers:
Removal
Inspection
Repair/Replace
Installation
INITIAL SETUP:
Tools:
Tool kit, service, refrigeration unit (Item 1, Appendix B)
Electric portable drill (Item 6, Appendix B)
Twist drill set (Item 7, Appendix B)
Blind riveter (Item 8, Appendix B)
Riveter (Rivnut) (Item 9, Appendix B)
Gloves, chemical (Appendix C)
Personnel: 1
Materials:
Adhesive compound (Item 1, Appendix E)
Bulk gasket material
Bulk insulation material
Rags (Item 12, Appendix E)
Methyl-ethyl ketone (MEK) (Item 13, Appendix E)
Equipment Conditions:
NOTE
For removal of the rear evaporator panel the air conditioner may have to be removed from the van or
shelter. Refer to the van or shelter technical manual for removal instructions.
REMOVAL
1.
Remove 10 screws (7), flat washers (9), and lockwashers (8) (see Figure 6-1).
2.
Lift panel (6) out slightly, loosen duct clamp (2) and remove hose (1).
3.
Rotate panel (6) counterclockwise and set on ground.
INPECTION
1.
Check that panel is not bent, cracked, or punctured.
2.
Check that gaskets and insulation are not torn, loose, or missing.
3.
Check rivets and rivnuts for missing or loose mounting hardware.
REPAIR/REPLACE
NOTE
Repair consists of replacing RFI gasket, insulation, rivnuts and rivets, or panel.
1.
For RFI gasket, insulation, or panel removal/installation remove the following components as necessary.
a.Remove/install thermostat box and cover (para 6-7).
b.Remove/install fresh air inlet box (para 6-8).
c.Remove/install fresh air damper operator bracket (para 6-9).
6-2
|
