|
| |
ARMY TM 9-4120-381-14
NAVY EE-000-CA-MMA-010/7053-AC
AIR FORCE TO 35E9-136-31
6-21. CONDENSER COIL REMOVAL - Continued.
2.
Rear of coil.
a.
Remove two screws (39), locknuts (38), and four washers (24) and (28)securing thermostat bracket (37) to
coil frame.
b.
Remove four screws (36), locknuts (28), and eight flat washers (29) and (35) securing refrigerant lines
support bracket (34) to coil frame.
c.
Debraze headers (23) and (33) from coil (para 5-14).
d.
Cut condenser damper actuator line (30).
e.
Pull condenser damper actuator line (30) through coil and frame.
WARNING
When handling coil, wear gloves to avoid injury to personnel and to reduce fin damage on the coil.
f.
Remove four screws (27), locknuts (32), and eight flat washers (26) and (31).
g.
Remove condenser coil (7) through front of frame.
INSTALLATION
1.
On replacement coil cut notch for damper actuator line.
WARNING
When handling coil, wear gloves to avoid injury to personnel and to reduce fin damage on the coil.
2.
Place coil (7) in mounting position.
3.
Front of Coil.
a.
Install upper bracket (8) to frame with seven screws (10), and fourteen flat washers (4) and (9), and four
locknuts (3).
b.
Install lower bracket (14) to frame with eight screws (12), sixteen flat washers (13) and (15).
c.
Secure front of coil to frame with four screws (22), eight flat washers (5) and (21), and four locknuts (6).
d.
Install wiring harness clamp with screw (20) and locknut (2).
e.
Install captive receptacle (18) with two rivets (19).
4.
Rear of Coil.
a.
Insert condenser damper actuator line (30) through coil (7) and frame.
b.
Place coupling on actuator line (30).
c.
Secure rear of coil to frame with four screws (27), eight flat washers (26) and (31), and four locknuts (32).
d.
Install thermostat bracket (37) to coil frame with two screws (39), four flat washers (24) and (38), and two
locknuts (25).
6-34
|
