Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: 2-18. OPERATION IN DUSTY OR SANDY CONDITIONS
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

ARMY TM 9-4210-381-14 NAVY EE-000-CA-MMA-010/7053-AC AIR FORCE TO 35E9-136-31 a. Check all openings in the enclosure, especially doors and windows, to be sure they are tightly closed.  Limit in and out traffic, if possible. b. Open shades and awnings to permit entry of direct rays of the sun, if appropriate. c. Limit the amount of cold, outside air introduced through the fresh air inlet to that needed for ventilation. 2-18. OPERATION  IN  DUSTY  OR  SANDY  CONDITIONS.    Dusty  and  sandy  conditions  can  seriously  reduce  the efficiency  of  the  air  conditioner  by  clogging  the  air  filters  and  thereby  causing  a  restriction  of  the  volume  of  airflow. Accumulation of dust or sand in the condenser coil and/or in the compressor compartment may cause overheating of the refrigeration system.  Dust or sand may also clog the condensate trap, and water drain lines.  Some of the steps that may be taken are: a. Frequent cleaning of filters and all other areas of dust and sand accumulation.  In extreme conditions, daily cleaning of filters may be necessary. b. Limit the amount of dusty or sandy outside air introduced through the fresh air inlet to that essential for ventilation. 2-19. OPERATION IN UNUSUALLY WET CONDITIONS.  The air conditioner is designed for normal exposure to the elements, so it is reasonably waterproof.  Some of the steps that should be taken in an extremely wet climate are: a. More frequent inspection and cleaning of the condensate trap and drain lines to insure proper drainage and prevent accumulation of water inside the cabinet. b. Cover the fresh air inlet on the back of the cabinet during periods of wet windy weather when the air conditioner is not in operation. 2-20. OPERATION  IN  SALT  AIR  OR  SEA  SPRAY.    Salt  air  or  sea  spray  may  cause  many  of  the  same  clogging problems encountered when operating in a dusty or sandy environment.  In addition, the nature of salt presents serious corrosion problems.  Frequent cleaning is necessary during which all exposed surfaces should be thoroughly spray rinsed or sponged with fresh water to remove salt. 2-21. OPERATION UNDER EMERGENCY CONDITIONS. a. Chemical, Biological, Radiological Hazard (CBR).  Should it be necessary to operate in conditions requiring use of CBR filtration equipment, see specific instructions for your shelter or facility installation.  The following are general suggestions and do not apply if they conflict with instructions for your shelter or facility installation. (1) The fresh air inlet should be closed, the opening should be covered with a suitable material, and sealed air tight. (2) The return air inlet should be partially or completely closed with a suitable material.  This will cause a more positive pressure on inside of shelter or enclosure and keep air from being drawn in from outside the enclosure. b. Power Conservation.  During periods when full 208 V ac, 3-phase power is in critically short supply, if the air conditioner cannot be turned off completely, it should be operated in AUTO mode only. 2-15/(2-16 blank)

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business