ARMY TM 9-4120-381-14 NAVY EE-000-CA-MMA-010/7053-AC AIR FORCE TO 35E9-136-31 Section IV.  REMARKS MAINTENANCE ALLOCATION CHART - Continued REF REMARKS CODE AD REPLACE BEARINGS AE WHEN REPLACING MOTOR, STRIP AND DEAD END WIRES TOGETHER FOR 208VAC, 3 PHASE OPERATIONINSTALL INSULATOR BUSHINGS TO MOTOR JUNCTION BOX. INSTALL AND CRIMP PIG TAILS TO WIRES AF TEST FOR PRESENCE OF AC VOLTAGE AG REPLACE BEARINGS, SHAFT AND/OR BEARING COLLAR.  REPLACEMENT SHAFT MUST BE CUT TO LENGTH. AH LUBRICATE IMPELLER SHAFT Al ADJUST PULLEY ON EVAPORATOR (CIRCULATOR) MOTOR AND/OR CONDENSER MOTOR FOR PROPER FAN ROTATION AJ INSPECT FOR LOOSE OR WORN FAN BELTS AK ADJUST FAN BELT TENSION FOR 1/2 INCH DEFLECTION AL SUBSTITUTE CAST IRON HARDWARE ON REPLACEMENT WITH STAINLESS STEEL. APPLY SEALANT COMPOUND^ AM CONTINUITY CHECK AN WHEN REPLACING CRANKCASE HEATER, PERFORM THE FOLLOWING ALTERATIONS: CUT CONDUIT TO 10 1/2 INCHES CUT WIRES TO -18 INCHES STRIP WIRE ENDS TO 1/2 INCH MAXIMUM. AO ADJUST LOW OIL PRESSURE LIMIT SET POINT AP ADJUST HIGH REFRIGERANT PRESSURE LIMIT SET POINT AQ ADJUST LOW REFRIGERANT PRESSURE LIMIT SET POINT AR DRILL (3) 5/32 INCH HOLES THROUGH TERMINALS OF REPLACEMENT PART AS ADJUST THERMOSTAT TO NOMINAL 72 DEGREES F AT ADJUST AND LOCK MINIMUM/MAXIMUM TEMPERATURE RANGE SETTING TO NOMINAL 68 AND 95 DEGREES F AU ADJUST THERMOSTAT TO NOMINAL 0 DEGREES F AV ADJUST PRESSURE TO 0.4 INCHES WC AW REPLACE FILTER ELEMENT UPON COMPRESSOR BURN-OUT OR WHENEVER REFRIGERANT SYSTEM IS OPENED FOR PURGING OR EVACUATION AX USE 9/16 X 2 INCH BOLTS FOR EARLY MODEL FILTER DRIER COVER PLATE AND 1/2 X 1 3/4 INCH BOLTS FOR LATER MODEL AY RAISE/LOWER SUPERHEAT SETTING AZ REPLACE CAGE ASSEMBLY AND/OR POWER HEAD ASSEMBLY BA STRIP AND DEAD END WIRES WHEN INSTALLING REPLACEMENT ITEM BB ADJUST FOR VALVE RESPONSE RATE AND/OR SUCTION PRESSURE BC ADJUST FOR DISCHARGE AIR TEMPERATURE BD REPLACE SUBORDINATE HARDWARE B-15