|
| |
ARMY TM 9-4120-381-14
NAVY EE-000-CA-MMA-010/7053-AC
AIR FORCE TO 35E9-136-31
Figure 4-2. Typical Crated Air Conditioner
4-8.
RECEIVING INSPECTION. Perform receiving inspection of the air conditioner as follows:
a.
Inspect. Inspect the unit for damage incurred during shipment. If the equipment has been damaged report
the damage on DD Form 6, Packaging Improvement Report.
b.
Check. Check the unit against the packing slip to see if shipment is complete. Report all discrepancies in
accordance with the instructions of DA PAM 738750.
c.
Modified. Check to see whether the equipment has been modified.
4-9.
INSTALLATION SITE PREPARATION. The air conditioner is designed so that it is adaptable to a variety of
installation arrangements. Most typical installations are made by preparing an opening in an exterior wall of the room or
enclosure to be conditioned and positioning the air conditioner so that the front of the cabinet is inside the room or
enclosure and the back is outside. Alternate installations may be made with the entire cabinet either inside or outside the
conditioned area.
a.
General. The following are minimum requirements for all installations. (See Figure FO-2 for installation
dimensions).
(1)
A relatively level surface capable of bearing the weight of the air conditioner on which to set the base.
To insure proper condensation drainage, the surface should be level within 5 degrees from front to
back and side to side.
(2)
An unobstructed flow of air from outside the conditioned area to the inlet and outlet of the condenser.
(3)
An unobstructed flow of air from inside the conditioned area to the conditioned air intake and
discharge.
(4)
An unobstructed flow of air from outside the conditioned area to the fresh air intake.
(5)
The supply air outlet is discharged from the bottom of the air conditioner (see Figure FO-2 ).
(6)
Access to the front (and back, if possible) of the cabinet for routine operation and servicing and for
necessary maintenance actions.
4-3
|
