INSTALLATION - TM-9-4120-423-14-P0118

TM9-4120-423-14&P

Using screwdriver, tag and disconnect terminal board leads from heaters and wiring harness.

Disconnect six terminal connecting links.

Using screwdriver, remove two screws that hold terminal board.

Remove the terminal board and marker strip.

If the terminal board support is to be removed, see WP0014 and separate the evaporator and

condenser section assemblies.

Using screwdriver and wrench remove the four screws and locknuts and remove the terminal

board support.

INSTALLATION

NOTE

If the terminal board support was not removed, skip steps 1 and 2

Using screwdriver and wrench, install the terminal board support with four screws and locknuts.

See WP0014 and reconnect the evaporator and condenser section assemblies.

Using screwdriver, install the terminal board and marker strip with two screws.

Connect the six terminal connecting links.

See tags and wiring diagram, and connect the leads from the heaters and wiring harness.

Remove the tags.

Secure thermostatic switch bracket to evaporator section back wall with four screws, four

locknuts and eight spacers.

Place thermostatic switches on protruding screw threads and secure each switch with two flat

washers, lockwashers, and locknuts.

See tags and wiring diagram and connect leads. Remove the tags.

Install top evaporator cover (See WP0026).

Install the fan and motor assembly (See WP0030).

Connect power.

0020 00-4