 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM9 4120-423-14&P
4
Using screwdriver and wrench, remove four each screws, flat washers, lockwashers, and nuts
that hold transformer to housing.
5
Lift transformer (T1) off.
INSTALLATION
1
Position transformer (T1) on module housing. Using screwdriver and wrench, install four each
screws, flat washers, lockwashers, and nuts.
2
Using knife, cut six pieces of heat shrinkable tubing, each one-half inch (1.27 cm) long and slide
onto wires and varistor.
3
Using soldering gun, solder leads to transformer terminals according to wire markings, tags, and
wiring diagram. Solder varistor (RV4) to terminals 7 and 8. Remove tags.
4
Slip piece of tubing over each transformer terminal and, using heat gun, shrink tubing in place.
5
Place cover on box and line up holes.
6
Using screwdriver, attach the cover with six screws and lockwashers. Do not over tighten, it will
cause distortion. See WP0041.
7
Install evaporator section electrical module assembly. See WP0032.
TESTING
Transformer (T1) Terminal Locations
0034 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals