 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM9-4120-423-14&P
2
Remove fuse. If fuse only is to be replaced, go to step (6) of installation.
3
If top cover has not been removed, use screwdriver to remove six screws and lockwashers.
Remove top cover.
4
Tag and unsolder leads to fuseholder.
5
Use wrench to loosen nut on rear of fuseholder.
6
Remove nut and fuseholder.
INSTALLATION
1
Insert fuseholder body through box and use wrench to secure nut.
2
Using knife, cut two pieces of heat shrinkable tubing, each one-half inch (1.27 cm) long and
slide onto leads.
3
See tags, wire marking or wiring diagram. Solder leads to fuseholder.
4
Remove tags.
5
Slip tubing into place over terminal and using heat gun, shrink tubing in place.
6
Push fuseholder cap in, turn and remove cap.
7
Insert fuse into fuseholder.
8
Place fuseholder cap in body and push in and turn to lock in place.
9
Place cover on box and line up holes.
10
Using screwdriver, attach the cover with six screws and lockwashers. Do not over tighten, it will
cause distortion. See WP0041.
11
Install top evaporator cover. See WP0026.
END OF TASK
0036 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals