REPAIR OR REPLACEMENT - TM-9-4120-423-14-P0211

TM9 4120-423-14&P

Using screwdriver and wrench, remove screws, lockwashers and nuts and remove the affected

connectors, harnesses, and gaskets.

REPAIR OR REPLACEMENT

See WP0015 for general wire repair instructions.

See Wire List for wire lengths and terminal information when individual wires are replaced.

TEST AND INSPECTION

Check connectors for general condition, loose, broken, or missing contacts. Replace connectors

if damaged.

Check individual wires for loose solder and terminal lug connections, cut or frayed insulation,

and cut or broken wires.

See wiring diagram and continuity test individual wires. Repair wires with no continuity.

Check that gaskets are in good condition. Replace them if they are torn, missing, or otherwise

damaged.

Check that disconnect splice connections are tight and in good condition. Replace if damaged or

loose.

Check that protective plastic tubing over disconnect splice connections are in place and in good

condition. Replace if missing, damaged, or loose.

INSTALLATION

Using screwdriver and wrench, install the connector(s) in box with screws, lockwashers, and

nuts. Be sure that gaskets are placed between connectors and box.

See tags and wiring diagram and reconnect leads. Remove tags.

Place cover on box and line up holes.

Using screwdriver, attach the cover with six screws and lockwashers. Do not over tighten, it will

cause distortion. See WP0041.

Install evaporator section electrical module assembly. See WP0032.

Install evaporator top cover. See WP0026.

END OF TASK

0042 00-3