REPAIR OR REPLACEMENT - TM-9-4120-423-14-P0225

TM9 4120-423-14&P

Carefully remove the left end condenser cover.

REPAIR OR REPLACEMENT

NOTE

Prior to removal of old gasket material, cut the new replacement material to size using the

old item as a sample.

Remove as much old gasket material as possible by pulling or scraping it away from the metal

surface.

WARNING

Dry Cleaning Solvent is flammable, and its vapors can be explosive. Repeated or

prolonged skin contact or inhalation of vapors can be toxic. Use a well-ventilated area,

and keep away from sparks or flame. Use goggles, gloves, and apron when appropriate.

Soften and remove old adhesive and gasket residue, using dry cleaning solvent and a stiff brush

To replace identification, danger, and diagram plates and lifting rings, use a drill bit slightly

smaller than the diameter of the rivet being removed.

Drill the rivets out and remove the old part.

Align holes in replacement part and cover and install new rivets.

Minor dents and bent edges can be straightened using common sheet metal repair procedures.

Panels that are badly dented, bent, or punctured should be replaced.

Should touch up or refinishing be necessary, see WP0016.

Use only approved replacement material as specified in Chapter 8.

EMI gasket material and regular gasketing specified for this unit are supplied with adhesive

backing.

Cut gasket to size. Be sure that EMI gasket corners are mitered so that good continuous edge

contact is made.

Be sure that surface to which gasket is to be applied is clean and free of paint and old adhesive

material.

Remove backing material from adhesive side and immediately press gasket in place. Be sure

that good edge-to-edge contact is made on the EMI gaskets.

0045 00-3