 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM9 4120-423-14&P
1
Remove as much old gasket or insulation material as possible by pulling or scraping it away
from the metal surface.
WARNING
Dry Cleaning Solvent is flammable, and its vapors can be explosive. Repeated
or prolonged skin contact or inhalation of vapors can be toxic. Use a well-
ventilated area, and keep away from sparks or flame. Use goggles, gloves, and
apron when appropriate.
2
Soften and remove old adhesive and gasket residue, using dry cleaning solvent and a stiff brush.
3
Use only approved replacement material as specified in Chapter 8.
4
EMI gasket material and regular gasketing specified for this unit are supplied with adhesive
backing.
5
Cut gasket to size. Be sure that EMI gasket corners are mitered so that good continuous edge
contact is made.
6
Be sure that surface to which gasket is to be applied is clean and free of paint and old adhesive
material.
7
Remove backing material from adhesive side and immediately press gasket in place. Be sure
that good edge-to-edge contact is made on the EMI gaskets.
INSTALLATION
1
Place EMI gasket on connector (J14) end.
2
Slip connector (J14) into box and align holes.
3
Using screwdriver and wrench, secure connector (J14) to inside of box with four screws,
lockwashers, and nuts.
4
Slip box and cover together and align holes.
5
Using screwdriver and wrench, secure box to cover with two screws and self-locking cap nuts.
6
Install remote control assembly in shelter. (See WP0057).
END OF TASK
0058 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals