REPAIR OR REPLACEMENT - TM-9-4120-423-14-P0297

TM9 4120-423-14&P

REPAIR OR REPLACEMENT

See WP0015 for general wire repair instructions.

See Wire List for wire lengths and terminal information when individual wires are replaced.

TEST AND INSPECTION

Using screwdriver and wrench, remove two screws and self-locking cap nuts that retain box to

cover.

Pull box away from cover as far as wiring harness will allow.

Check connector for general condition, loose, broken, or missing pins. Replace connector if

damaged.

Check individual wires for loose solder and terminal lug connectors, cut or frayed insulation, and

cut or broken wires.

See wiring diagram and continuity test individual wires. Repair wires with no continuity.

Check that gasket is in good condition. Replace if torn, missing, or otherwise damaged.

INSTALLATION

See tags and wiring diagram and reconnect leads.

Remove tags.

Place EMI gasket on connector (J14) end.

Slip connector (J14) into box and align holes.

Using screwdriver and wrench, secure connector (J14) in proper position to inside of box with

four screws, lockwashers, and nuts.

Slip box and cover together and align holes.

Using screwdriver and wrench, secure box to cover with two screws and self-locking cap nuts.

Install remote control assembly in shelter. See WP0057.

Connect power.

END OF TASK

0063 00-3