Shelter/Enclosure Preparation

TM 9-4120-428-14

0016 00

.38 IN (.97 CM) MAX (WITH FABRIC

26.33 IN

COVER IN PLACE)

(66.88 CM)

CONDENSER FABRIC COVER (TIED IN

POSITION FOR UNIT OPERATION)

16.00 IN

(40.64 CM)

HANDLE (2 EACH SIDE)

RIGHT SIDE VIEW

BOTTOM PANEL OF

AIR CONDITIONER

.25 IN (.64 CM) MAX

RESILIENT

MOUNTS

ELASTOMERIC

TUBE

SPACER

CAP SCREW

WASHER

ENCLOSURE MOUNTING

PLATE

CROSS SECTION OF BOTTOM

MOUNTING HOLE AND

HARDWARE

(TYPICAL 4 PLACES)

1. Remove the condensate drain plug from the lower left rear corner of the air conditioner. Connect a drain line if the

air conditioner is mounted in a location where water pouring from the drain is objectionable or creates a hazard. The

fitting must have a male 1/8 27 NPT connection to the unit. Hose, rigid pipe, or tubing can be used to directly drain

water to a more desirable location.

2. Connect the power cable to input power source. (F9000H-4SPFI, 208 volt, 3 phase, 400 hertz air conditioner)

3. Run operational checks in accordance with WP 0017 00.

NOTE

For more information on air conditioner installations, refer to MIL-HDBK-116,

Environmental Control of Small Shelters.

0016 00-9