 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-4120-XXX-14&P
0021 00
WARNING
Do not use near an open flame or excessive heat. Dry cleaning solvent that is used to
clean parts is potentially dangerous to personnel and property.
CLEANING
1. When necessary, wipe or brush dirt from the louver. If louver is extremely dirty, it may be washed following the same
process as the filter.
2. Immerse the filter in a mild detergent solution or dry cleaning solvent.
3. Agitate until dirt is removed, using a soft brush to loosen caked-on dirt.
4. Rinse in clean water.
5. Drain, then hold the filter horizontal and tap each edge on a bench or the floor to remove any excess water droplets.
6. Be sure the filter is completely dry prior to installation.
INSPECTION
1. Check the filter (4) for punctures, cuts, or damaged edges that allow for passage of unfiltered air.
2. Check the filter (4) for packed or mashed areas that would block the airflow.
3. Replace the filter (4) if necessary.
INSTALLATION
1.
Apply air filter coater to the filter sparingly.
2.
Airflow arrows should point away from louver.
3.
Place the filter (4) in retainer clips.
4.
Secure the louver (3) with screws (1) and lock washers (2).
NOTE
FOLLOW-ON MAINTENANCE:
Connect power at the power source.
END OF WORK PACKAGE
0021 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals