AC DOES NOT COOL OR COOLS INADEQUATELY - continued

DRAFT

TB 9-2320-364-13&P-1

AC DOES NOT COOL OR COOLS INADEQUATELY - Continued

WARNING

Remove rings, bracelets, wristwatches, neck chains, and any other jewelry before working around

vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry or tools may short

across electrical circuits or terminals and cause damage to equipment or severe burns or

electrical shock to personnel.

AC condenser assembly weighs 75 lbs. (34 kg). Do not lift AC condenser assembly without the aid

of an assistant. Failure to comply may result in injury to personnel and/or damage to equipment.

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

VERIFY REPAIR

(1)

If running, shut off engine (TM 9-2320-364-10).

(2)

If removed, install heater access panel and eight

screws (TM 9-2320-364-20).

(3)

If removed, install right ECB side panel and ten

screws (TM 9-2320-364-20).

(4)

Install AC condenser dryer sight glass access hole

cover.

(5)

If removed, install cover and four washers,

lockwashers, and screws on AC condenser

assembly (WP 0028).

(6)

If removed, install AC condenser assembly and

four screws (WP 0028).

(7)

Remove AC test set recovery/recycling gages

(WP 0053).

(8)

Perform leak test (WP 0052). Concentrate on AC

system service valves.

(9)

Repair any leaks found.

(10) Install driver side noise panel (WP 0051).

(11) Start engine (TM 9-2320-364-10).

(12) Operate AC system for 10 minutes at high blower

speed (WP 0004).

(a) If AC system does not provide adequate

cooling, fault has not been corrected. Shut off

engine, turn fan control switch and

temperature control switch to off position, and

notify Supervisor.

(b) If AC system provides adequate cooling, fault

PLSAC160

has been corrected.

END OF WORK PACKAGE

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

0015-35/(0015-36 blank)