|
| |
TM5-4120-376-14
4-16. CONDENSER FAN MOTOR/Inspect, Service, Test, Replace (Cont)
LOCATION/ITEM
Repair:
CAUTION
Keep load spring, shims and washers in their proper relationships at
disassembly, they will be needed at assembly.
1. Remove eight screws (1) and end plates (2) from motor.
2. Withdraw the rotor (3) from the stator.
3. Using an arbor press or equivalent, press the bearings (4) off of the end rotor, being
careful to avoid cocking.
4. Blow loose dirt from cavities and windings.
5. Remove four screws (5) securing thermal overload cover (6) to condenser motor housing.
6. Remove thermal overload cover and retaining spring (7).
7. Pull thermal overload (8) out and away
terminals.
8. Unsolder terminals in accordance with
from condenser
Appendix E.
motor housing, to gain access to
9. Remove and replace thermal overload.
4-54
|
