AC HEATER/EVAPORATOR BLOWER OPERATES BUT NO COLD AIR FROM DUCTS DURING AC OPERATIONS (Cont)

DRAFT

TB 9-2320-279-13-1

AC HEATER/EVAPORATOR BLOWER OPERATES BUT NO COLD AIR FROM

DUCTS DURING AC OPERATIONS - Continued

WARNING

Remove rings, bracelets, wristwatches, neck chains, and any other jewelry before working around

vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry or tools may short

across electrical circuits or terminals and cause damage to equipment or severe burns or

electrical shock to personnel.

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

CONTINUITY TEST

NOTE: Do not disconnect wires from AC condenser

motor.

(1) Remove AC condenser motor (WP 0026).

(2) Set multimeter switch to ohms.

(3) Place positive (+) probe of multimeter on red wire at

AC condenser motor terminal.

(4) Place negative (-) probe of multimeter on red wire at

AC condenser motor solenoid terminal.

(a) If there is no continuity, repair AC condenser

motor power wire (see Appendix A). Verify

repair, go to Step 27 of this fault.

(b) If there is continuity, go to Step 19 of this fault.

HEMAC161