 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TB 9-2320-279-13-1
2. CONDENSOR INSTALLATION.
This task covers:
a. Condensor Installation.
References
INITIAL SETUP
None
Models
Equipment Condition
All
None
Test Equipment
Special Environmental Conditions
None
None
Special Tools
General Safety Instructions
None
None
Supplies
Air Conditioner Condensor
Connector 2 Pin
(2) Socket Contact
(2) Seal
Grab Handle
(2) Flat Washer-3/8 in.
(6) Lockwasher-3/8 in.
(2) Screw-3/8-16 x 1 in.
(4) Plate
(4) Flange Screw-3/8-16 x 2 in.
Personnel Required
MOS 52C, Utilities equipment repairer (2)
a.
Condensor Installation.
1.
Install grab handle (1) on
condensor (2) with two screws (3),
lockwashers (4), and washers (5).
NOTE
If condensor does not have
connector installed on two wires,
perform Steps 2 through 12.
If condensor has connector
installed on two wires, go to
Step 13.
2.
From edge of condensor (2), cut
two wires (6 and 7) to
8 in. (203 mm).
0052-17
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals