AC HEATER/EVAPORATOR BLOWER OPERATES BUT NO COLD AIR FROM DUCTS DURING AC OPERATIONS - continued

DRAFT

TB 9-2320-364-13&P-1

AC HEATER/EVAPORATOR BLOWER OPERATES BUT NO COLD AIR FROM

DUCTS DURING AC OPERATIONS - Continued

WARNING

Remove rings, bracelets, wristwatches, neck chains, and any other jewelry before working around

vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry or tools may short

across electrical circuits or terminals and cause damage to equipment or severe burns or

electrical shock to personnel.

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

VOLTAGE TEST

(1) If OFF, turn engine start switch ON

(TM 9-2320-364-10).

(2) Place positive (+) probe of multimeter on AC

condenser assembly harness black wire at AC

condenser motor solenoid terminal.

(3) Place negative (-) probe of multimeter on a known

good ground.

(a) If 22 to 28 vdc are not measured, turn engine

start switch OFF and repair AC condenser

assembly harness black wire (see Appendix A).

Verify repair, go to Step 29 of this fault.

(b) If 22 to 28 vdc are measured, go to Step 21 of

this fault.

PLSAC195

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -