AC COMPRESSOR DOES NOT SHUT OFF OR CYCLES CONSTANTLY - continued

DRAFT

TB 9-2320-364-13&P-1

AC COMPRESSOR DOES NOT SHUT OFF OR CYCLES CONSTANTLY - Continued

WARNING

Remove rings, bracelets, wristwatches, neck chains, and any other jewelry before working around

vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry or tools may short

across electrical circuits or terminals and cause damage to equipment or severe burns or

electrical shock to personnel.

AC condenser assembly weighs 75 lbs. (34 kg). Do not lift AC condenser assembly without the aid

of an assistant. Failure to comply may result in injury to personnel and/or damage to equipment.

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

VERIFY REPAIR

(1) If removed, install AC condenser motor (WP 0025).

(2) If removed, install cover and four washers,

lockwashers, and screws on AC condenser fan

motor solenoid assembly (WP 0026).

(3) If removed, install AC condenser assembly and four

(4) If loose, tighten locknut on cushion clip (WP 0028).

(5) If disconnected, connect AC harness AC condenser

assembly connector (WP 0028).

(6) If disconnected, connect AC harness wire 1435 to

AC condenser assembly (WP 0028).

(7) If removed, install heater compartment access panel

and eight screws (TM 9-2320-364-20).

(8) If installed, remove driver side noise panel

(9) Turn engine start switch ON (TM 9-2320-364-10).

(10) Operate AC system for 10 minutes at high blower

(a) If AC compressor does not shut off or cycles

constantly, fault has not been corrected. Shut off

engine, turn fan control switch and temperature

control switch to off position, and notify

Supervisor.

(b) If AC compressor operates correctly, fault has

been corrected.

PLSAC160

(11) Install driver side noise panel (WP 0051).

END OF WORK PACKAGE

0014-19/(0014-20 blank)