AC HEATER/EVAPORATOR BLOWER MOTOR RESISTOR HARNESS REPLACEMENT

DRAFT

TB 9-2320-364-13&P-1

0036

AC HEATER/EVAPORATOR BLOWER MOTOR RESISTOR HARNESS

REPLACEMENT

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

THIS WORK PACKAGE (WP) COVERS:

Removal

Installation

Follow-On Maintenance

INITIAL SETUP:

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

Maintenance Level

Materials/Parts

Field Level Maintenance

Tags, Identification (Item 10, Appendix E)

Tape, Insulation, Electrical (Item 11, Appendix E)

Equipment Condition

Lockwashers (4) (Item 4, Figure 5, Appendix G)

Batteries disconnected (TM 9-2320-364-20).

Personnel Required

Heater/defroster tubing (upper plenums) removed

One

(TM 9-2320-364-20).

Tools and Special Tools

References

Tool Kit, Electrical (Item 8, Appendix F)

TM 9-2320-364-20

Tool Kit, General Mechanic's (Item 9, Appendix F)

REMOVAL

PLSAC067

NOTE

Tag and mark wires and connectors prior to removal to ensure proper installation.

1. Remove screw (1), lockwasher (2), washer (3), and ground wire (4) from heater/evaporator (5). Discard

lockwasher.

2. Remove three screws (6), lockwashers (7), washers (8), and cover (9) from heater/evaporator (5).