INSTALLATION - TB-9-2320-364-13-P-10393

DRAFT

TB 9-2320-364-13&P-1

AC OPTIC RIBBON LIGHT SOURCE WIRE HARNESS REPLACEMENT - Continued

INSTALLATION

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

PLSAC118

1. Install bulb (10) in lamp socket (8).

PLSAC119

2. Install lamp socket (8) in light source (9).

NOTE

Insulation being removed from wire 1052 in Step 3 is from cab wire harness.

3. Remove 1/4 in. (6 mm) of insulation from end of wire 1052 (6).

NOTE

Ensure all strands of wire 1052 are inside terminal when installing.

4. Install butt splice (7) of wire 1052 (11) over bare wire ends of wire 1052 (6) and crimp securely.

5. Inspect wire splice to ensure no bare wire is visible.

6. Install ground wire (4) on heater/evaporator (5) with washer (3), lockwasher (2), and screw (1).

0043-3