INSTALL (Cont) - TM-10-4110-262-13-P0135

TM 10-4110-262-13&P

0023 00

WARNING

Keep fingers away from forklift tines while removing the

RU. Fingers could get pinched between the RU and the

forklift tines. Failure to comply may result in serious injury

to personnel.

6. Using a spotter inside and outside of the IC, direct the forklift driver to slowly insert the evaporator

section into the opening. The inside spotter shall guide the evaporator section through the opening in

the container and align the bolt holes in the back plate with the threaded inserts in the IC wall.

7. Align the condensate drain tube fitting on the IC rear wall with the corresponding hole in the RU back

plate.

8. Install eight mounting bolts through the bolt holes snugly, then tighten after all bolts are installed.

NOTE

The top four bolts are shorter than the lower mounting bolts.

9. Reconnect the external condensate drain tubes.

CAUTION

Do not over-tighten the RU mounting bolts. Over-tightening these bolts

may debond the threaded inserts from the IC structure causing container

leaks and reducing the security of the RU mounting.

NOTE

If a threaded insert is stripped replace it.

10. Connect the IC power supply cord to the IC power entry connector.

11. Reconnect the condensate hoses from the evaporator to the nipples on the drain pan.

12. Connect the RU power supply cord to an appropriate source of power. Turn on the power at the

source.

13. Operate the RU as described in Work Package 0005 00.

0023 00-5