|
| |
TM 10-4130-239-14
4-37.
WATER PUMP REPLACEMENT (CONT)
17. Remove faceplate from pump shaft.
18. Remove socket-head screw.
Side
away
NOTE
of faceplate with three screw holes faces
from pump.
1.
Place outer faceplate on water pump shaft against body of water
pump.
2.
3.
4.
5.
6.
Place locking
Install drive
locking key.
While sliding
key in slot on water pump shaft.
hub on end of water pump shaft in alignment with
drive hub back on water pump shaft, place faceplate
loosely on drive hub.
Push water pump drive hub assembly back against water pump.
Adjust to provide clearance of at least 0.010 in. (0.25 mm)
between assembly and water pump.
Install two socket-head screws in faceplate.
4-83
|
