|
| |
Removal and cleaning
of interior components:
Do not operate unit with panels removed.
1.
Turn the Cycle Control Knob to "OFF" and
disconnect the electrical power supply to the machine.
Open the storage bin door and remove any ice that is in
the bin.
FIGURE 6
2.
Remove ice retainer baffle by flexing it (Figure 6)
and then slide it off the studs.
3.
Remove the ice cutter grid by unscrewing the two
thumb screws, sliding the grid forward and unplugging the
electrical wire harness.
FIGURE 7
4.
Remove the water pan by unscrewing the two
thumb screws (Figure 7).
FIGURE 8
5.
Remove the hose from the water pump. Clean
the water inlet hose hanging in the water pan. (Figure 8)
FIGURE 9
6.
Remove the water distributor from the freezing
plate. It is held in place by rubber end caps. Remove the
inlet hose and clean all water distributor holes and the
small orifice in the inlet side of the distributor. When
replacing the distributor, make sure the end caps are
located in the evaporator flange detents and that the
water distributor holes face down.
7.
Wash the interior components (ice retainer
baffle, cutter grid, water pan, inlet hose and water
distributor) and the storage bin, door gasket and ice scoop
with mild soap or detergent and warm water. Rinse in
clean water. These components should also be cleaned
in a solution of 1 oz. (29.6 ml) of chlorine bleach in 1
gallon (3.8 L) warm water.
DO NOT WASH PLASTIC PARTS IN DISHWASHER.
They cannot withstand temperatures above 145°F
(63°C).
8.
Replace
the
interior
components:
water
distributor, inlet hose and water pan.
9.
Check the following: * Hose from water valve is in
water pan.
•
Rubber drain plug is in water pan.
•
Water distributor is seated and holes are facing
down.
•
Hose
is
reconnected
to
pump
and
water
distributor.
•
Hose from water pan is inserted into storage bin
drain opening.
10.
Reconnect electrical harness, slide cutter grid into
place and tighten the thumb screws, replace the ice
retainer baffle.
11.
Turn Cycle Control to "ON."
5
|
