Figure 5-6. Field Ground Test (Model RMP-J/l-IOG) .

TM 5-4110-217-14

Figure 5-7. Test for Open Field Coil (Model RMP-J/1-

IOG)

Figure 5-4. Test for Grounded Armature (Model RMP-

/1-IOG)

CAUTION

Do not immerse bearing equipped parts in cleaning fluid.

Clean with a brush dipped in mineral spirits. Do not

immerse the overrunning clutch in cleaning solvent.

(2) Apply 20 weight oil to armature shaft and

splines Use grease sparingly on intermediate bear-

ing assembly and spacing washers at end of the

shaft.

g Reassembly Reverse disassembly procedure,

paragraph (b) above. Use spacing washers to adjust

armature end play of 0.004 to 0.020 inch.

h. Installation. Refer to paragraph 3-42c and install

starter. Check pinion clearance (fig. 5-8) between

starting motor pinion gear and flywheel ring gear.

Figure 5-5. Checking Commutator Runout (Model RMP

/1-IOG)

Figure 5-6. Field Ground Test (Model RMP-J/l-IOG) .

Figure 5-8. Pinion Clearances (Model RAfP-J/1-IOG)

(Pinion shown In retracted position).

Change 3 5-3