|
| |
b. Installation. Install condenser coil as follows:
( 1 ) If angle was removed from condenser, rivet
angle to coil with four blind rivets.
(2) Be sure sheet spring nuts are in place on
bottom of coil, Position coil in air conditioner and
install four countersunk-head screws from un-
derside of housing.
(3) Refer to paragraph 4-20 and install
condenser guard.
(4) Connect tubing to condenser and install
any other tubes and fittings that were removed.
(5) Attach bulb well clamp to angle with
screw.
(6) Refer to paragraph 4-21 and install
housing top covers.
(7) Refer to paragraph 6-3 and charge the
refrigerant system.
5-20. Condenser Louver Actuator and Control
a. Removal. Remove actuator and push-pull
control as follows:
(1) Refer to paragraph 6-3 and discharge the
refrigerant system.
(2) Refer to paragraph 4-21 and remove
housing covers.
(3) Refer to figures 5-5 and 5-6 and loosen
mechanical post screws to loosen control wire.
5-9
|
