|
| |
(4) Disconnect tubing as required to permit
removal of compressor.
(5) Remove four screws, washers, lock
washers, and compressor mount bushings.
(6) Lift compressor from air conditioner.
Caution: If compressor is being replaced
because of a motor burnout, decontaminate
system as instructed in paragraph 6-5. Failure
of the replacement compressor will result if all
the contaminates are not removed.
c. Installation. Refer to figure 5-2 and install
compressor as follows:
(1) Place compressor on mounts and install
four compressor mount bushings. Secure com-
pressor with four screws, washers and lock washers.
(2) Connect tubing.
(3) Connect electrical connector.
(4) Refer to paragraph 4-21 and install
housing top covers.
(5) Refer to paragraph 6-3 and charge the
refrigerant system.
5-18. Evaporator Coil
a. Removal. Remove the evaporator coil as
follows :
(1) Refer to paragraph 6-3 and discharge the
refrigerant system.
(2) Refer to paragraph 4-21 and remove
housing top covers.
(3) Refer to paragraph 4-18 and remove
evaporator air outlet louver.
(4) Refer to figure 5-3 and remove screw that
secures bulb well loop clamp to evaporator coil
angle.
Figure 5-3. Evaporator coil, removal and installation.
5-6
|
