|
| |
T M
5 - 4 1 2 0 - 2 5 9 - 15
STEP 5.
STEP 6.
STEP 7.
STEP 8.
STEP 9.
STEP 10.
NOTE:
NOTE:
REMOVE THE 6 SCREWS AND NUTS THAT SECURE THE REAR AND BOTTOM
OF LEFT SCROLL TO THE UNIT, AND ROTATE SCROLL SO OUTLET POINTS
TOWARD FRONT.
REMOVE DUAL PRESSURE SWITCH MOUNTING SCREWS AND, BEING CARE-
FUL NOT TO BEND OR KINK TUBING, PLACE THE SWITCH TO ONE SIDE
WHILE REMOVING MOTOR MOUNTING.
REMOVE 4 MOTOR MOUNTING BOLTS.
SLIDE MOTOR TOWARD FRONT SO THAT SCROLL CAN BE ROATATED FOR–
WARD AND REMOVE LEFT SCROLL.
REMOVE CONDENSER FAN MOTOR FROM LEFT SIDE OF UNIT.
REMOVE THE 6 SCREWS AND NUTS THAT SECURE THE RIGHT SCROLL IN
PLACE AND REMOVE RIGHT SCROLL FROM FRONT OF UNIT.
LEFT SCROLL AND FAN MOTOR MUST BE REMOVED BEFORE RIGHT SCROLL
CAN BE REMOVED.
REVERSE REMOVAL PROCEDURE FOR INSTALLATION. INSTALL FAN
GUARDS IN BOTTOM PANEL WHILE MOUNTING SCROLLS. ADJUST MOTOR
POSITION TO CENTER IMPELLERS IN SCROLLS. ALL ARROWS SHOULD
SHOW CLOCKWISE ROTATION WHEN VIEWED FROrA LEFT SIDE OF UNIT.
INSTALL IMPELLER HUBS SO THEY ARE EVEN WITH ENDS OF MOTOR
SHAFT.
ROTATE BY HAND TO ASSURE RUNNING CLEARANCE. REPLACE
DUAL PRESSURE SWITCH.
Figure 17. Condenser Fans And Motor, Removal And Installtion (Cont’d).
b. Removal and Installation. To replace the
opened, and components disconnected at con-
two main cabinet harnesses, the front and right
nectors or quick disconnects. The connectors
side panels must be removed, all clamps
must be unmounted from the partitions where
29
|
