|
|
TM 5-4120-273-15
BASIC ISSUE ITEMS LIST AND MAINTENANCE AND
OPERATING SUPPLIES
Section I. INTRODUCTION
Code
Explanation
B-1. Scope
item, and the failure of which should result
This appendix lists items which accompany the air
in retirement of the end item from the supply
conditioner or are required for installation, oper-
system.
X1
Applied to repair parts which are not procured
ation, or operator's maintenance.
or stocked, the requirement for which will be
supplied by use of the next higher assembly
B-2. General
or component
This Basic Issue Items List is divided into the fol-
X2
Applied to repair parts which are not stocked.
lowing sections:
The indicated maintenance category requiring
a. Basic Issue Items-Section II. This section
such repair parts will attempt to obtain them
through cannibalization; if not obtainable
is a listing of accessories, repair parts, tools and
through cannibalization, such repair parts
publications required for operator's maintenance
will be requisitioned with supporting justifi-
and operation, initially issued with, or authorized
cation through normal supply channels.
for the air conditioner.
Applied to repair parts authorized for local
C
b. Maintenance and Operating Suppl&s-Sec-
procurements. If not obtainable from local
procurement, such repair parts will be requisi-
tion III. This section is a listing of maintenance
tioned through normal supply channels with
and operating supplies required for initial opera-
a supporting statement of nonavailability
tion,
from local procurement.
G
Applied to major assemblies that are procured
B-3. Explanation of Columns
with PEMA (Procurement Equipment Missile
Army) funds for initiaI issue only to be used
The following provides an explanation of col-
as exchange assemblies at DSU and GSU
umns in the tabular list of basic issue items, sec-
level or returned to depot supply level.
tion II:
Note. Source code is not shown on common
a. Source, Maintenance, and Recoverability
hardware items known to be readily available
Codes (SMR), Column (1):
in Army supply channels and through local
procurement.
(1) Source code indicates the selection status
and source for the listed item. Source codes are:
(2) Maintenance code indicates the lowest
Explanation
Code
category of maintenance authorized to install the
P
Applied to repair parts which are stocked in
listed item. The maintenance level code is:
or supplied from GSA/DSA Army supply
Explanation
Code
system, and authorized for use at indicated
maintenance categories.
C
Operator/crew
M
Applied to repair parts which are not procured
(3) Recoverability code indicates whether
or stocked but are to be manufactured at
unserviceable items should be returned for re-
indicated maintenance categories.
Applied to assemblies which are not procured
A
covery or salvage. Items not coded are expendable.
or stocked as such, but made up of two or
Recoverability codes are:
more units, each of which carry individual
Explanation
Code
stock numbers and descriptions and are pre-
cured and stocked and can be assembled by
Applied to repair parts and assemblies which
R
are economically reparable at DSU and GSU
units at indicated maintenance categories.
X
Applied to parts and assemblies which are not
activities and are normally furnished by
procured or stocked, the mortality of which is
supply on an exchange basis.
normally below that of the applicable end
Applied to high dollar value recoverable repair
T
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |