Appendix C. MAINTENANCE ALLOCATION CHART

MAINTEANCE ALLOCATION CHART

Section I. INTRODUCTION

C-1. General

a. This section provides a general explanation of all maintenance

and repair functions authorized at various maintenance levels.

b. Section II designates overall responsibility for the perform-

ance of maintenance functions on the identified end item or compo-

nent. The implementation of the maintenance functions upon the end

item or component will be consistent with the assigned maintenance

functions.

Section III - Special Tools and Test Equipment. Not applicable

d. Section IV - Supplemental Instructions. Not applicable

C-2. Explanation of Columns In Section II

a. Group Number. Column 1. The functional group Is a numerical

group set up on a functional basis. The applicable functional group-

ing indeces (obtained from TB 750-93-1, Functional Grouping Codes)

are listed on the MAC in the appropriate numerical sequence. These

indexes are normally set up in accordance with their function and

proximity to each other.

b. Functional Group. Column 2. This column contains a brief

description of the components of each functional group.

c. Maintenance Functions. Column 3. This column lists the

various maintenance functions (A through K) and indicates the lowest

maintenance category authorized to perform these functions. The sym-

bol designates for the various maintenance categories are as fol-

lows:

C - Operator or crew

O - Organizational maintenance

F - Direct support maintenance

These maintenance functions are defined as follows:

C-1