Table 2-2. INITIAL OPERATOR CONTROL SETTINGS

TM5-4120-347-14

TABLE 2-2

INITIAL OPERATOR CONTROL SETTINGS

Fabric

Conditioned Air

Return Air

Fresh Air

Temperature

Mode

Cover

Supply Louver

Louver

Damper

Selector

Mode

Selector

. Optional

Optional

Fully Open

Fully Closed

VENTILATE

Any Setting

Ventilation

with 100%

recirculated

Air

Open

Optional

Partially Open Partially

VENTILATE

Any Setting

Ventilation

(Rolled)

Closed

with make-

up fresh air

Open

Optional

Fully Closed

Fully Open

Any Setting

VENTILATE

Ventilation

(Rolled)

with 100%

Fresh Air

LOW HEAT or Desired

Heating with

Temperature

100%. Recir-

HIGH HEAT

culated Air

Open

Partially or

Slightly Downward

Partially or

LOW HEAT or Desired

Heating with

(Rolled)

Fully Closed

Fully Open

Temperature

make-up

HIGH HEAT

Fresh Air

Open

Slightly Upward

Fully Open

Fully Closed

Desired

COOL

Cooling-with

(Rolled)

Temperature

100%. Recir-

culated Air

Open

Slightly Upward

Partially or

Cooling with

Desired

COOL

(Rolled)

Fully Closed

Fully Open

make-up

Temperature

Fresh Air

Open

Partially or

Optional

Fully Open

Any Mode-

Desired

(Rolled)

Fully Closed

Mode

with make-up

Temperature

Air Through

CBR Filter

NOTE

Under some climatic conditions, local practices mav be established to close the fresh air dapermere

and/or roll down and snap in place the fabric cover during shutdown periods. If such practices are in

effect, the operator must first unsnap, roll up and secure the fabric cover and appropriately adjust the

fresh air damper before turning the mode selector switch to the desired operating mode.

2-8. INFORMATION PLATES

A number of information plates are provided on the exterior of the air conditioner cabinet. These plates are

located on, or adjacent to, the control or device to which they apply. See figure 2-3 for locations and printed

information.

2-9.

PREPARATION FOR MOVEMENT

No special operator preparation is required when the air conditioner is to be moved to another location.

Simply close the louvers in the evaporator intake and discharge grilles, close the fresh air damper, and roll

down and snap in place the fabric cover on the back of the cabinet.

2-8