Evaporator Coil and Mist Elimimotor holder

TM 5-4120-352-14

(4) Refer to figure 4-5 and install housing top

(6) Lift compressor from air conditioner.

covers.

(5) Refer to paragraph 6-3 and discharge the

CAUTION

refrigerant system.

If compressor is being replaced be-

cause of a motor burnout, decon-

5-18. Evaporator Coil and Mist Elimi-

taminate system as instructed in para-

nator Holder.

graph 6-5. Failure of the replacement

a. Removal. Remove the evaporator coil and

compressor will result if all the con-

mist eliminator holder as follows:

taminants are not removed.

(1) Refer to paragraph 6-3 and discharge the

refrigerant system.

c. Instailation. Refer to figure 5-2 and install

(2) Refer to figure 4-5 and remove housing top

compressor as follows:

covers.

(1) Place compressor on mounts and install

(3) Refer to figure 4-2 and remove evaporator

four compressor mount bushings. Secure com-

air outlet louvers and mist eliminator.

pressor with four screws, washers and lock washers.

(4) Refer to figure 5-3 and disconnect tubing

(2) Connect tubing.

from evaporator coil.

(3) Connect electrical connector.

(5) Remove six screws, washers, and lock

washers and lift evaporator coil and angle; also mist

eliminator holder, from air conditioner.

5-9