|
|
TM 5-4120-355-14
a. Removal. Refer to figure 4-5 and remove panels and grilles.
b. Inspection and Repair. Inspect for minor dents, and cracked or chipped paint. Repair minor damage and repaint.
c. Installation. Refer to figure 4-5 to install panels and grilles.
4-16. Canvas Condenser Cover.
a. Removal. Refer to figure 1-2. Remove retaining hardware and lift off cover.
b. Inspection and Repair. Inspect for rips or tears. Repair with waterproof tape.
c. Installation. Place cover in position and secure with retaining hardware.
4-17. Fresh Air Inlet Screen, CB Inlet Screen, Condenser Fan Guard and condenser Coil Grille.
a. Removal. Refer to figure 4-4. Remove fresh air inlet screen, CB inlet cover, condenser fan guard, and condenser
coil grille.
b. Inspection, Inspect for minor dents and cracked or chipped paint. Repair minor damage and repaint.
c. Installation. Install the fresh air inlet screen, CB inlet cover, condenser fan guard, and condenser coil grille.
Section IX. General Organizational Maintenance Instructions
4-18. compressor.
Test for continuity across n-rotor windings with multimeter set on OHMS. Refer to wiring diagram, figure 1-3, to
establish points of continuity.
a. Rernoval Refer to figure 4-6 and remove the motor.
b. Inspection and Testing.
(1) Inspect for dents, cracks, and broken or darnaged leads.
(2) Test for continuity across windings with a multimeter set on OHMS. Refer to figure 1-3 to establish points
of continuity.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |