Chapter 3. ORGANIZATIONAL MAINTENANCE INSTRUCTIONS

TM 5-4120-356-14

CHAPTER 3

ORGANIZATIONAL MAINTENANCE INSTRUCTIONS

S e c t i o n I. Repair Parts, Special Tools, TMDE, and Support Equipment

3-1.

COMMON TOOLS AND EQUIPMENT

For authorized common tools and equipment, refer to the Modified Table of Organiza-

t i o n a l and Equipment (MTOE) applicable to your unit.

3-2.

SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT

There are no special tools, TMDE, or support equipment r e q u i r e d to perfom Organiza-

tional Maintenance on the air conditioner.

3-3. REPAIR PARTS

R_Lp a i r p a r t s a r e l i s t e d a n d i l l u s t r a t e d i n t h e R e p a i r P a r t s a n d S p e c i a l T o o l s L i s t

T M 5-4120-356-24P covering Organizational Maintenance of this equipment.

Section II. Service Upon Receipt

ASSEMBLY AND PREPARATION FOR USE

3-4.

Unpacking.

(1) Move the air conditioner to t h e i n s t a l l a t i o n site before removing

s h i p p i n g c o n t a i n e r . Cut the metal bands and r e m o v e top, end, a n d s i d e s o f c a r t o n ,

a n d the inner covering. R e m o v e bolts securing base of unit to carton, and using

t h e handles, lift unit from carton.

( 2 ) Inspect the equipment for damage incurred during shipment. If the

equipment has been damaged, report the damage on DD form 6, Packaging Improvement

Report.

( 3 ) Check the equipment against the packing slip to see if the ship-

m e n t is complete. R e p o r t all discrepancies in accordance with the instructions of

TM 38-750.

(4) Check to see if the equipment has been modified.

(5) Prior to placing the unit in operation, accomplish depreservation

i n a c c o r d a n c e with the instructions outlined in DA Form 2258 (Depreservation Guide

o f Engineer Equipment). D A Form 2258 is attached to or near the operational controls.

b . Assembly.

There are no assembly procedures. However, the air conditioner

should be inspected after receipt as follows:

3-1