EMI GASKETS. WARNING HARNESS AND LEADS

TM 5-4120-359-14

b. Removal

(1) Using screwdriver and wrench, remove eight screws, six nuts, and two lock washers that hold cover to

chassis.

(2) Pull cover away from chassis as far as wiring harness will allow.

(3) Using screwdriver and wrench, remove four screws and lock nuts from each of the two connectors.

(4) Separate the cover from the connectors and EMI gaskets. Take care that EMI gaskets are not lost.

Installation

(1) Slip EMI gasket on connector ends.

(2) Insert connector ends through holes in cover and aline holes.

(3) Using screwdriver and wrench, secure connectors and EMI gaskets with eight screws and lock nuts.

(4) Position cover on chassis.

(5) Using screwdriver and wrench, secure cover to chassis with eight screws, six lock nuts, and two lock

washers.

Follow-on Procedures: 1. Install condenser section electrical module. (See paragraph 4-90.)

2. Connect power.

4-92. EMI GASKETS. WARNING HARNESS AND LEADS

Preliminary Procedures:

1. Disconnect power.

2. Remove condenser section electrical module. (See paragraph 4-90.)

a. Inspection/Test

(1) Using screwdriver and wrench, remove eight screws, six nuts, and two lock washers that hold cover to

chassis.

(2) Pull cover away from chassis as far as wiring harness will allow.

4-186