|
| |
TM 5-4120-359-24P
c. National Stock Number. Indicates the National Stock Number assigned to the item and which will be used
for requisitioning.
d. Part Number. Indicates the primary number used by the manufacturer (individual, company, firm, cor-
poration, or Government activity), which controls the design and characteristics of the item by means of its
engineering drawings, specifications, standards, and inspection requirements to identify an item or range of
items.
NOTE
When a stock numbered item received may have a different
part number than the part being replaced.
c. Federal Supply Code for manufacturer (FSCM). The FSCM is a 5-digit numeric code listed in SB 708-42
which is used to identify the manufacturer, distributor, or Government agency, etc.
f. Description. Indicates the Federal item name and, if required, a minimum description to identify the item.
The physical security classification of the item is indicated by the parenthetical entry (insert applicable physical
security classification abbreviation, e.g., Phy Sec C1 (C)-Confidential, Phy Sec C1 (S) -Secret, Phy Sec C1 (T)-
Top Secret). Items that are included in kits and sets are listed below the name of the kit or set with the quantity
of each item in the kit or set indicated in the quantity incorporated in unit column. When the part to be used
differs between serial numbers of the same model, the effective serial numbers are shown as the last line of the
description. In the Special Tools List, the initial basis of issue (BOI) appears as the last line in the entry for each
special tool, special TMDE, and other special support equipment. When density of equipments supported ex-
ceeds density spread indicated in the basis of issue, the total authorization is increased accordingly.
g. Unit of Measure (U/M). Indicates the standard of the basic quantity of the listed item as used in perform-
ing the actual maintenance function. This measure is expressed by a two-character alphabetical abbreviation
(e.g., ea, in, pr, etc.). When the unit of measure differs from the unit of issue, the lowest unit of issue that will
satisfy the required units of measure will be requisitioned.
h. Quantity Incorporated in Unit. Indicates the quantity of the item used in the breakout shown on the
illustration figure, which is prepared for a functional group, subfunctional group, or an assembly. A "V" appearing
in this column in lieu of a quantity indicates that no specific quantity is applicable, (e.g., shims, spacers, etc.).
4 SPECIAL INFORMATION.
a. Usable on codes are shown in the description column. Uncoded items are applicable to all models. Iden-
tification of the usable on codes used in this RPSTL are:
Code
Used On
D HF
KECO MODEL F18H4-2
E KP
AIRTACS MODEL MSP-18-4-08
F GG
FERANGE MODEL FAC-MH-18S
b. Detailed manufacturing instructions for items source coded to be manufactured or fabricated are found .
in TM 5-4120-359-14. Bulk materials required to manufacture items are listed in the Bulk Material Group of
this manual.
c. Detailed assembly instructions for items source coded to be assembled are found in TM 5-4120-359-14. .
Assembly components are listed immediately following the item to be assembled.
d. Repair parts kits and gasket sets appear as the last entries in the repair listing for the figure in which its
parts are listed as repair parts.
e.
The following publication pertains to Model F18H4-2 and model AIRTACS MODEL
M S P - 1 8 - 4 - 08
Publication and Short Title
TM 5-4120-359-14
Maintenance Manual
4
Change 3
|
