|
| |
Figure 6-4.
TM 5-4120-361-14
flange at top. Sleeve passes through
the coil spring.
(1) Remove four screws (1). Re-
move end bell (2).
(7) Install coil housing, data
(2)
plate, and nut.
(3)
6-8.
Fan Motors.
(4)
a. General.
Except for the shaft on
move end
the rotor, the condenser fan motors and
Remove end bell bearing (3).
Remove rotor (4).
Remove four screws (5). Re-
bell (6) from stator (7).
the evaporator fan motor are identical,
(5) Remove screw (8) and loop clamp
therefore, the following instructions
(9).
Remove screws (10) and remove
apply equally to either motor.
cable (11) from motor.
b. Disassembly. Refer to figure 6-4
(6) Remove bearing (12) and spacer
and disassemble motor as follows:
(13) from end bell (6).
1
6-7
|
