 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-4120-369-14
IDENTIFICATION.
a.
Identification. Each air conditioner has one major identification plate mounted on
the side of the unit. The plate specifies nomenclature, military part number, BTU/hr., phase,
hertz, volts, serial number, contract number, shipping weight, the manufacturer's name and
address, and the model and serial numbers.
The air conditioner has the following information plates pertinent
Information Plates.
b.
to operation.
It is located on the top of the unit. This illustrates
(1) Wiring Diagram Plate.
complete air conditioner wiring.
(2) Fluid Diagram Plate. It is located on the top of the unit. The plate illustrates
complete air conditioner refrigerant system.
(3) Ventilation Instruction Plate. It is located on the right front side of the unit.
This plate indicates the direction to turn vent adjusting knob to open or close the damper
door in the ventilation air duct.
It is located on the front of the unit. This
(4) Control Module Instruction Plate.
plate indicates the following.
(a) The ON and OFF positions of the control circuit breaker.
(b) The ON and OFF position of the compressor circuit breaker.
(c) The various heating and cooling positions for the mode selector switch.
(d) Temperature increase and decrease positions for temperature selector switch.
(e) The HIGH and LOW position of the evaporator fan speed switch.
(f) The manufacturer's model number of the unit.
(5) Operation Caution Plate. It is located on the front of the unit above the control
module. This plate warns to see TM for proper and safe operation.
(6) High Pressure and Low Pressure Reset Plates. They are located on the left
side of the unit below the control module. These plates indicate location of the high and low
pressure reset buttons.
(7) Service Valves (Charging). The high pressure and low pressure service valves
(charging) are located on the top left side of the unit inside the service valves (charging) access
panel. These plates indicate the location of the service valves (charging).
(8) Danger Warning Plate. It is located on the left side of the air conditioner near
the front. This plate warns of the hazard in operating the air conditioner without a grounding
wire.
(9) Nameplate. It is located on the left side of the air conditioner near the front,
and contains the manufacturer's name, the air conditioner serial and model number and other
pertinent nameplate data.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals