 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-4120-374-13
ACTION
REMARKS
LOCATION/lTEM
a. Align holes in condenser coil with holes in base.
9.
Condenser
Coil
b. Secure condenser coil to base from the underside with
four (4) screws.
c. Align holes in condenser shroud with holes in condenser
coil.
d . Secure condenser shroud with six (6) screws.
e. Secure condenser shroud to frame with two (2) screws.
f . Reposition condenser fan on motor shaft until hub is flush
with end of shaft and tighten setscrew in hub.
g. Refer to paragraph 5-7 and solder two (2) refrigerant lines
to condenser coil.
REAR OF HOUSING
a. Align holes in rear panel with holes in housing.
10. Rear Panel
b. Secure rear panel with fourteen (14) screws.
TOP AND LEFT SIDE OF HOUSING
a. Align holes in left side panel with holes in housing.
11. Left Side Panel
b. Secure left side panel with seventeen (17) screws.
a. Align holes in top rear panel with holes in housing.
12. Top Rear PaneI
b. Secure top rear panel with nine (9) screws.
Refer to paragraph 5-7 and charge refrigerant system.
13. Refrigerant
Servicing
14. Top Center Panel a. Align holes in top center panel with holes in top fron t and
rear panels.
b. Secure top center panel with ten (10) screws.
5-31
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals