|
| |
TM5-4120-376-14
4-17. EVAPORATOR FAN MOTOR AND HOUSING ASSEMBLY/Inspect, Service, Test, Repair,
Replace (Cont)
LOCATION/ITEM
Repair:
8. Solder terminals on thermal overload (60) in accordance with Appendix E.
9. Cement thermal overload (60) to block.
10. Align thermal overload (60) and mounting block (61) with holes in end plate.
11. Secure thermal overload and mounting block to end plate with four screws (58) and four
star washers (59).
12.
13.
Insert rotor (56) into motor housing (57).
Align end plate (55) with holes in motor housing (57).
NOTE
Ensure that drain holes in end plates and housing are at bottom of motor.
14. Tap end plate lightly with rubber hammer to seat bearing into end plate.
15. Secure end plates (56) to motor housing (57) with four screws (51) four flat washers (52)
four star washers (53) and four lock nuts (54).
16. Align, secure and clamp to motor housing (57) with one star washer (49) and one screw
(48).
4-67
|
