|
| |
TM5-4120-376-14
4-22. JUNCTION BOX AND CONTROL MODULE ASSEMBLY/Inspect, Test, Replace (Cont)
LOCATION/ITEM
Installation:
Temperature Selector (S-3)
1. Align temperature selector (S-3) (34) with holes in control module mounting frame (13).
2. Secure temperature selector (S-3) to control module mounting frame with three screws
(45) three flat washers (46) and three lock nuts (47).
3. Attach wires to appropriate terminals.
4. Align temperature selector sensor bulb cap line and one clamp (44) with hole in control
module mounting f ram e.
5. Secure temperature selector sensor bulb cap line and one clamp to control module
mounting frame with one screw (41) one flat washer (42) and one lock washer (43).
6. Attach temperature selector knob (35) to temperature selector (S-3).
7. Secure temperature selector knob to temperature selector by tightening set screw (33).
Mode Selector (S-1)
1. Align mode selector (29) with holes in control module mounting plate.
2. Secure mode selector to control module mounting plate with one lock washer (31) and one
retaining nut (32).
3. Attach wires to appropriate terminals in accordance with Appendix E and remove tags.
4. Attach mode selector knob (28) to mode selector.
5. Secure mode selector knob to mode selector with two set screws (27).
Evaporator Fan Speed (S-2)
NOTE
When installing (S-2) adjust lock nut so that outer nut is flush with shaft
threads.
1. Align evaporator fan speed (S-2) (24) with holes in control module mounting
plate.
2. Secure evaporator fan speed to control module mounting plate with one lock
washer (26) and one retaining nut (25).
4-104
|
