| |
TM5-4120-376-14
4-22. JUNCTION BOX AND CONTROL MODULE ASSEMBLY/Inspect, Test, Replace (Cont)
LOCATION/ITEM
Installation:
3. Attach wires to appropriate terminals and remove tags.
Circuit Breaker (CB1) (Compressor)
1. Align circuit breaker (CB1) (20) with holes in control module mounting plate.
2. Secure circuit breaker to control module mounting plate with six flat washers (22) and six
screws (21).
3. Attach wires to appropriate terminals and remove tags.
Circuit Breaker (CB2) (Control)
1. Align circuit breaker (CB2) (15) with holes in control module mounting plate.
2. Secure circuit breaker to control module mounting plate with one lock washer (17) and one
retaining nut (16).
3. Attach wires to appropriate terminals and remove tags.
4. Align control module cover (12) with holes control module mounting frame.
5. Secure control module cover to control module mounting frame with four screws (11).
Control Module
1. Slide thermostat sensor bulb (7) thru junction box to left evaporator fan housing (8).
2. Secure thermostat sensor bulb to left evaporator fan housing with two clamps (6) two lock
washers (5) and two screws (4).
3. Slide control module into junction box (10).
4. Secure control module (5) to junction box with knob (9).
4-105
|