|
| |
TM5-4120-376-14
4-23. AMBIENT THERMOSTAT AUXILIARY POWER INLET/Inspect, Test, Repair, Replace
(Cont)
LOCATION/ITEM
Removal:
8. Tag and remove wires from
terminal board (22) and ground
screw (23).
9. Remove inlet connector assy
(J-1).
Inspection:
1. Inspect for damage.
2. Repair or replace if damaged.
Repair:
1. To repair broken or cut wires
and spliced.
2. A commercial butt splice can
be made.
that are otherwise sound, the mating ends can be stripped
be crimped onto the ends to join them, or a wire splice can
3. A wire splice is made by stripping one 1 1/4 inches of insulation from the wire ends,
holding the ends parallel and facing opposite directions, then twisting each end around the other
wire at least three turns.
4. Solder and apply heat-shrink tubing.
4-129
|
