|
| |
TM5-4120-377-14
b. Removal
(4)
Tag and disconnect wire leads.
Using screwdriver and wrench, remove four screws and nuts from terminal board (TB2).
Using screwdriver, remove four screws and flat washers from terminal board (TB1).
Remove terminal boards.
c. Installation
(1)
(2)
(3)
(4)
Using screwdriver, secure terminal board (TB1) with four screws and flat washers.
Using screwdriver, pliers, and wrench, secure terminal board (TB2) with four each screws and nuts.
See tags and wiring diagram (fig. 4-20) and connect wire leads.
Remove tags.
Follow-on procedure: Install junction box cover and lower front panel. (See para 4-47.)
4-59. JUNCTION BOX HOUSING, PANEL, AND COVER
Preliminary procedure: Remove junction box. (See para 4-46.)
Figure 4-70. Junction Box Housing, Panel, and Cover
a. Access
(1) Using screwdriver, loosen four captive panel fastener screws in junction box cover.
(2) Remove cover.
4-111
|
