LOCATION AND DESCRIPTION OF MAJOR COMPONENTS.

TM5-4120-383-14

1-5.

EQUIPMENT CHARACTERISTICS, CAPABILITIES, AND FEATURES.

-Continued

hertz input power, a suitable ground and an entry to a suitable

drain. The drain must be lower than the base of the cabinet, in

its operating location, for disposal of condensate waste water. It

is designed to operate in almost any environmental condition from

artic to tropic and is fully portable for movement from one

location to another.

The primary installation requirement is that the exhaust air

from the compressor/condenser section must be vented to the outside

atmosphere. This subject is fully covered in the installation

instructions contained in Chapter 4, "Organizational Maintenance

Instructions."

e. When using this equipment in a secure area, caution must be

exercised in meeting the established electromagnetic radiation

standards. These standards may limit the use of the equipment's

remote capability and require additional shielding for the ducts.

LOCATION AND DESCRIPTION OF MAJOR COMPONENTS.

(See fig. 1-2 Sheets 1 and 2)

1 FABRIC COVER. Protects back or exposed side of the unit

during periods of shut down. Must be rolled up when operating in

the cool mode or when fresh (outside) air is being used in any mode.

2 CONDITIONED AIR SUPPLY LOUVER.

Provides directional control

of conditioned air.

3 CONDITIONED (EVAPORATOR) AIR FAN. Draws the room or

enclosure air in over the filter and blows it out over the

evaporator and heaters to supply conditioned air. The speed is

adjustable.

See Item 16.

4 TEMPERATURE SELECTOR (THERMOSTAT) SENSING BULB. Senses the

temperature of the room or enclosure air as it is drawn back into

the air conditioner. This bulb is part of the TEMPERATURE SELECTOR

control (thermostat) that is located on the control panel module.

5 CONDITIONED AIR FILTER.

Filters room or enclosure air as it

is recirculated.

6 CONDITIONED AIR FAN MOTOR.

Drives the conditioned air fan.

7 RETURN AIR LOUVER WITH FILTER CLAMPS. The recirculated air

from the room or enclosure is drawn in through this louver. The

conditioned air filter, item 5, is mounted on clips on the inside

of this louver.

1-3