Section II. SERVICE UPON RECEIPT OF EQUIPMENT

TM5-4120-383-14

4-1.

GENERAL.-Continued

Rubber Gloves

Safety Goggles

Screwdriver, Cross Tip

No. 2 One Inch Long Blade

5120-00-227-7293

Screwdriver Offset, Cross

Tip No. 1

5120-00-256-9014

Section II

SERVICE UPON RECEIPT OF EQUIPMENT

4-2.

SITE AND SHELTER REQUIREMENTS.

The air conditioner is designed so that it is adaptable to a

variety of installation arrangements. Most typical installations

are made by preparing an opening in an exterior wall of the room or

enclosure to be conditioned and positioning the air conditioner so

that the front of the cabinet is inside the room or enclosure and

the back of the cabinet is outside.

Alternate installations may be

made with the entire cabinet either inside or outside the

conditioned area. The following are minimum requirements for all

installations:

a. A relatively level surface capable of bearing the weight of

the air conditioner on which to set the base. To insure proper

condensate drainage, the surface should be level within 5 f r o m

front to back and side to side. See fig. 4-1, Sheets 1, 2 and 3

for mounting dimensions.

b. An unobstructed flow of air from outside the conditioned

area to the intake and discharge of the condenser fan (back face of

air conditioner).

c. An unobstructed flow of air from inside the conditioned area

to the conditioned air supply and discharge openings (front face of

air conditioner).

d. An unobstructed flow of air from outside the conditioned

area to the fresh air intake (back face of air conditioner).

e. Access to the front and back of the air conditioner for

routine operation and servicing and for necessary maintenance

actions.

f. Access to and sufficient headroom to allow removal of the

front and rear top panels is necessary, if the unit is to be

serviced when installed.

4-3