Section V MAINTENANCE PROCEDURES - TM-5-4120-383-140087

TM5-4120-383-14

Section V

MAINTENANCE

PROCEDURES

4-9.

GENERAL.

The procedures in this section have been arranged in the order in

which the items appear in the organizational (O) maintenance level

column on the Maintenance Allocation Chart (MAC) which is provided

in Appendix B. Step-by-step procedures have been provided for all

action authorized to be performed by organizational maintenance in

the order in which they appear on the MAC. Actions authorized to

be performed by direct and general support maintenance have been

duly noted; step-by-step procedures for these actions may be found

in Chapters 5 and 6 respectively.

FABRIC

COVER

The fabric cover is made of vinyl impregnated nylon cloth.

It is

used to cover the exposed condenser (rear) openings during periods

of shutdown or storage.

Inspect for rips, cuts, tears, or punctures in

Inspection.

the fabric, and for damaged or missing snap fasteners and eyelets.

Refer repair or replacement to direct support maintenance.

b. Cleaninq. Wash the fabric cover using a solution of fresh

water and a mild detergent. A soft scrubbing brush may be used to

remove caked deposits. Thoroughly rinse with fresh water and air

dry.

c. Lubrication. Apply silicone spray lubricant to the snap

fasteners, if they are difficult to open and close.

(1) Unsnap four snap fasteners.

(2) Remove three sets of screws, lock washers, and flat

washers.

Lift fabric cover from unit.

Installation.

(1) Secure fabric cover to the unit with three sets of

screws, lock washers, and flat washers.