Click here to make tpub.com your Home Page

Page Title: CONTROL MODULE WIRING HARNESS.-Continued
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM5-4120-383-14
CONTROL MODULE WIRING HARNESS.-Continued
426.
Inspect.
a.
(1) Disconnect power at power source.
(2) See paragraph 4-21a and remove control module.
(3) See figure 4-22 and remove four screws and pull the cover
off.
(4) Inspect connector for loose, damaged or missing pins.
Replace if defective.
(5) Check individual wires for loose solder connections,
loose terminal lugs, cut or frayed insulation, cut or broken wires.
b.
Removal.
(1) Loosen setscrew in TEMPERATURE SELECTOR knob. Remove
knob.
(2) Remove three screws from the posts and slip the back
plate off.
(3) Tag and disconnect wires from components and ground stud.
(4) Remove attaching hardware and pull connector from back
plate.
See the wiring diagram figure 4-4.
c.
Testing.
Replace
test individual wires to corresponding pin in connector.
or repair wires with no continuity.
Repair.
d.
(1) See paragraph 4-20 for general wire repair instructions.
(2) See table 4-3 Wire List for wire lengths and terminal
information when individual wires are replaced.
Replace individual wires and terminals if
e.  Replace.
defective.
f.
Installation.
(1) Slip connector into back plate and secure with screws,
nuts and washers.
(2) See the wiring diagram figure 4-4 and tags and connect
wire leads.  Remove tags.
4-74

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business