 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-4120-384-14
4-10. FABRIC COVER. - Continued
Inspect for rips, cuts, tears, or punctures in
Inspection.
a.
the fabric, and for damaged or missing snap fasteners and eyelets.
Refer repair or replacement to direct support maintenance.
Cleaning.
Wash the fabric cover using a solution of fresh
b.
A soft scrubbing brush may be used to
water and a mild detergent.
Thoroughly rinse with fresh water and air
remove caked deposits.
dry.
Apply a silicone spray lubricant to the snap
Lubrication.
c.
fasteners, if they are difficult to open and close.
d.
Removal.
(Models F18H-3S and F18H-1S)
(1)
Unsnap
five
snap
fasteners.
Remove four sets of screws, lock
washers,
and
flat
(2)
Lift fabric cover from unit.
washers.
Removal.
(Models F18H-3SA and F18H-3SB)
(1)
Unsnap
seven
snap
fasteners.
Remove six sets of screws, lock
washers,
and
flat
(2)
washers.
Lift fabric cover from unit.
(Models F18H-3S and F18H-1S)
e.
Installation.
(1) Secure fabric cover to
the
unit
with
four
sets
of
screws,
lock
washers, and flat washers.
(2) If unit
is
to
be
put
back
into
service,
roll
cover
up
and
tie
in place.
(3) If unit is to be stored or shut down
for
an
extended
period, roll cover down and secure snaps.
(Models
F18H-3SA
and
F18H-3SB)
Installation.
(1) Secure fabric cover to
the
unit
with
six
sets
of
screws,
lock washers, and flat washers.
(2) If unit
is
to
be
put
back
into
service,
roll
cover
up
and
tie
in place.
(3) If unit is to be stored or shut down
for
an
extended
period, roll cover down and secure snaps.
4-38
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals